60A 30×30 ESC for higher-current FPV builds
The SpeedyBee BLS 60A 30×30 4-in-1 ESC is a 3–6S board for FPV builds that need a standard 30.5×30.5 mm stack pattern and up to 60A continuous current per motor. Its BLHeli_S J-H-40 firmware supports DShot300 and DShot600, while the onboard current sensor can be calibrated in the flight-controller setup.
Confirmed specifications
- Input: 3–6S LiPo
- Continuous current: 60A per channel / 240A combined
- Burst current: 80A per channel / 320A combined for up to 10 seconds
- Firmware and protocols: BLHeli_S J-H-40; DShot300 / DShot600
- Mounting: 30.5×30.5 mm pattern with 4 mm holes
- Board size and mass: 45.6×44×8 mm; 23.5g
- Protection and filtering: TVS diode, 3oz copper PCB, aluminum-alloy heatsink, 20 onboard SMD capacitors
- Included accessory: external 1000µF low-ESR capacitor
Installation notes
Fit the supplied capacitor close to the battery pads, confirm the frame supports 30×30 board clearance and configure the current sensor in the FC. This ESC does not support ESC telemetry, so do not plan a build that depends on telemetry over the ESC signal lead.
Availability note: The manufacturer lists this legacy ESC as discontinued. This listing is available on backorder only; contact 100drone before ordering if you need a current compatible replacement.
