XROCK 3DR Radio Telemetry Module SPECIFICATIONS
Колесная база: Винты
Модернизация деталей/аксессуаров: Адаптер
Тип устройства: Pack
Поставки инструментов: Резка
Технические параметры: Значение 2
Размер: ОПИСАНИЕ
Периферийные устройства/устройства дистанционного управления: Пульт дистанционного управления
Рекомендуемый возраст: 12+y
Рекомендуемый возраст: 14+y
Запчасти и принадлежности RC: Разъемы/проводка
Количество: 1 шт.
Вес упаковки: 0.14kg (0.31lb.)
Размер упаковки: 10cm x 15cm x 10cm (3.94in x 5.91in x 3.94in)
Происхождение: Материковый Китай
Номер модели: 3DR Radio Telemetry
Материал: Композитный материал
Атрибуты полного привода: Сборка
Для типа автомобиля: Самолеты
10KM XROCK 3DR Radio Telemetry Module 500mW 915Mhz 433Mhz Air Ground Interchangeable for APM PIXHAWK Pixhack RC Drone
Особенности:
– Air and Ground end is interchangeable
– Range: around 10000M
– Compatible with APM,PX4,PIXHAWK,PIXHACK,JIYI P2,JIYI P2 PRO
– Support:MissionPlanner,DroidPlanner,AndroPilot,PlayUAV
– 915Mhz
– Receive sensitivity: -110 dBm
– Transmite power: 100dBm(500mW)
– MAVLink protocol framing status documents
– Frequency modulation and Spread spektrum (FHSS)
– Self adaption to time duvision multiplexing
– Support LBT and AFA
– Could configure duty ratio
– Built-in error correcting code(up to 25% data bit error)
– Open source firmware
– AT command configure data transmission
– RT command remote control data transmission
– Based on HM-TRP wireless module, with Si1000 8051 micro controller and Si4432 wireless module
Размеры:
55 x 25 x 13.5 mm (without antenna)
Electrical Data:
Supply Voltage: 5V DC (from USB or JST-GH)
Transmit Current: 110 mA at 20dBm
Receive Current: 55 mA
Serial Interface: 3.3 V UART
pairing steps
1. Power on the data transmission module, the green light flashes.
2. Press and hold the pairing button for 3 seconds, the red light flashes quickly to enter pairing mode. Pairing mode lasts 10 seconds.
3. Supply power to another data transmission module within 10 seconds, the green light is always on, indicating that the pairing is successful
1. Power on the data transmission module, the green light flashes.
2. Press and hold the pairing button for 3 seconds, the red light flashes quickly to enter pairing mode. Pairing mode lasts 10 seconds.
3. Supply power to another data transmission module within 10 seconds, the green light is always on, indicating that the pairing is successful
Packing Content:
– 1 x Telemetry Module for air
– 1 x Telemetry Module for Ground
– 2 x Folding Antenna
– 2 x 4-wire connector cable
– 1 x TYBE-C to TYBE-C Cable
Russian 
English 
Отзывы
Отзывов пока нет.